All sectors

Road construction and paving

Inspections and handovers in road construction

During a road survey you record where a defect starts and ends and which part of the paving it concerns.

Request a demo
Inspector checking the edge of new asphalt next to a road marking

What matters in this sector

Damage to a road is a line or an area, not a point. A photo of a crack says little if nobody knows which road section it is in and how far it runs.

With Maintainspect you record the finding on the site drawing and note which road section it belongs to. At a handover you check asphalt, markings and joints and share the punch list with the contractor.

Assignments you use it for

  • Road survey per section
  • Handover of asphalt and markings
  • Survey before and after works

What do you look for during the inspection?

  • Asphalt and paving
  • Markings
  • Joints and verge edges

A question from practice

Where does the damage start and end? A photo alone does not say. Record the road section and the position with it, so the contractor can go straight there.

How you record it

  1. 01

    Photo of the road marking

    Take the photo and record what it is and what condition it is in. The finding is filed under Road section 3.

  2. 02

    Record the location

    Do you have a site drawing? Tap the spot where you are standing. Without a drawing you pick or type the location, for example Road section 3.

  3. 03

    Check and report

    The overview shows what is still open, for example under asphalt and paving. Then you share the report.

Schematic view of the tool.

Related sectors

Discuss your inspection

Tell us which locations and components you inspect. We will show how that works in the tool.

Request a demo