Road construction and paving
Inspections and handovers in road construction
During a road survey you record where a defect starts and ends and which part of the paving it concerns.
Request a demo
What matters in this sector
Damage to a road is a line or an area, not a point. A photo of a crack says little if nobody knows which road section it is in and how far it runs.
With Maintainspect you record the finding on the site drawing and note which road section it belongs to. At a handover you check asphalt, markings and joints and share the punch list with the contractor.
Assignments you use it for
- Road survey per section
- Handover of asphalt and markings
- Survey before and after works
What do you look for during the inspection?
- Asphalt and paving
- Markings
- Joints and verge edges
A question from practice
Where does the damage start and end? A photo alone does not say. Record the road section and the position with it, so the contractor can go straight there.
How you record it
01
Photo of the road marking
Take the photo and record what it is and what condition it is in. The finding is filed under Road section 3.
02
Record the location
Do you have a site drawing? Tap the spot where you are standing. Without a drawing you pick or type the location, for example Road section 3.
03
Check and report
The overview shows what is still open, for example under asphalt and paving. Then you share the report.
Related sectors

Underground infrastructure and sewers
Recording in the open trench or inspection per pipe section and manhole

Bridges, tunnels and hydraulic structures
Inspection of concrete, bridge joints, retaining walls or tunnel installations
Discuss your inspection
Tell us which locations and components you inspect. We will show how that works in the tool.
Request a demo